Allureglow USA PS Series Phthalate Free Plastisol Glow in the Dark Screen Printing Ink

This Allureglow USA PS Series Glow in the Dark Screen Ink is a Non-Phthalate Soft Hand Glow in the Dark Screen  Printing Ink. The PS Series is manufactured using only Phthalate Free Plasticizers and is compliant with all State and Federal Regulations concerning Phthalates.
Allureglow PS Series Glow in the Dark Inks enable the screen printer to print on either light or dark 100% cotton garments. This Ink can also be used on other fabrics and vinyls with the addition of our AG-CLA-100 Additive. Consult SDS prior to using.

Directions and Helpful Information:

The Allureglow USA PS Series Glow in the Dark Inks are a  Single Component Ready to Use Ink, just mix it up and it is ready to use.

Mixing should be done with a high speed drill or drill press using a Type 2 Dispersion Blade. Continue to mix Ink occasionally throughout production run.

Keep lids on containers to avoid contamination of the Ink

If Ink is to thin for larger opening screens, the use of Allureglow USA LTS-1959 Thickner at a rate of 1/2% by Weight of Ink, Mix Throughly and Allow the Ink to Sit for 2-4 Hours Prior to Using.

The. use of a Lint Catcher or Overcoat Clear for dark fabrics will aid in uninterrupted production and reduce fibrillation. Create a single screen by combining all of the colors in the image to be printed on a dark 100% cotton fabric. Print using a suitable Primer Clear through a 230 mesh count and then flash cure.

YOU MUST USE A WHITE UNDERBASE OR PRINT ON ALL GRAMENTS OTHER THAN WHITE. YOU WILL GREATLY REDUCE THE GLOW INTENSITY BY NOT DOING THIS STEP.

For Best Results A Heavy Flood and Slow to Moderate Squeegee Pressure on Automatic Presses and Heavy Flood and Light to Moderate Squeegee Pressure on Manual Presses is recommended. A Print /Flash/Print Method will achieve the best results

Allureglow USA PS-2045 can be printed using 86-180 Mesh Screens depending on the color and amount of glow you are trying to achieve.

Cure Ink at 320°F (160°C) Always Test Dryer Temperatures prior to and during production. Curing Time will be between 90 to 180 seconds, depending on amount of ink deposit and color of garment.

Always perform wash test prior to production, to ensure proper adhesion to the fabric, prior to production runs.

Clean-Up can be done using Bio-Degradable Screen Wash

Testing and viewing can best be done in a dark room, after charging the print in sunlight for 10 minutes or under artificial light for 30 minutes. Always allow your eyes to adjust for a few minutes after entering the dark room.

For best long term durability wash in cold water on the delicate cycle and wash inside out. Do Not Use Bleach. Do Not Iron on Print. Line or Hang Dry.

Any application not referenced in this Technical Data should be pre-tested prior to any production run is done.
Manufactured By: Allureglow USA and Allureglow USA makes no representation as to the suitability of any given products; it is up to the buyer or user to determine if the product is suitable for the given application. Call:(888) 493-4569 or email: info@allureglowusa.com

Click on the Link for a copy of the TDS

NOTE: All Standard Colors are suitable for Outdoor Use 

Fluroescent Colors are for Indoor Use Only Fluroescent Colors will fade if Used Outdoors

Colors may vary depending on the type of Ink Used  

Consult Technical Data and Safety Data Sheets prior to using any Allureglow USA Products

For Technical Assistance Call (888) 493-4569